The ECO Dryer 2.0 HP is by far the market’s most effective, quietest and most energy-efficient drying cabinet. And it’s also extremely attractive! Three rows of collapsible, pull-out hangers, plus double glove rack on the inside of the door.
Our new drying cabinet uses heat pump technology to achieve even more effective and gentler drying while achieving still greater energy savings – and an even lower noise level which makes it as quiet as a modern refrigerator. And you save up to 65% of energy compared to a normal manual drying cabinet.
Dimensions H x W x D
1930 x 595 x 675 mm
Weight
95 kg
- Energy-efficient heat pump technology
- Quiet
- Requires no extract air ventilation
- Two fully automatic programmes
| Egenskap | |
|---|---|
| Dimensions H x W x D | 1930 x 595 x 675 mm |
| Weight | 95 kg |
| Protection class | IP24, SEMKO- och CE approved |
| Capacity | Hanging length 16 metres, normal load 4 kg |
| Noise level | 52 db(A) – in principle no louder than a refrigerator |
| Electrical connection | Connect to normal wall outlet, one phase 230 V 10 A |
| Snabbtorkande | Up to 22 g water per minute. |
| Energy consumption | 1.3 kWh with normal load (4 kg). Down to 0.28 kWh/kg with maximum load (8 kg) |
| Connection | Requires no extract air ventilation |
| Door hanging left | Art. no.: 65110100, RSK no.: 8035860, E no.: 9200002 |
| Door hanging right | Art. no.: 65120100, RSK no.: 8035865, E no.: 9200003 |
The display shows an alarm message, e.g. Error 4
Reset the alarm by depressing the Start/stop button for 5 seconds. If the alarm remains, call a service technician.
How often must the filter be cleaned?
Ideally after every drying process.
The drying cabinet doesn’t work
Check that:
– the plug is inserted in the wall outlet
– no fuses have tripped
– the start button is activated
– the door is closed
– the tank is empty
The display shows Empty water tank
– Empty the water tank
– Check that the cap is fitted so that the float arm protrudes from the opening.
– Check that the water tank is turned inwards in the drawer and correctly inserted.
– If the cabinet still doesn’t work, contact a service technician.
The door doesn’t seal correctly/gapes
– Check that the cabinet is level. Check with a spirit level and adjust the cabinet feet if necessary.
– Check that the filter and its holder are correctly installed. The holder should be pressed down towards the underlying heat pump unit in order to seal correctly.
– Check that no leaves, gravel etc. have become caught beneath the filter holder, preventing it from sealing correctly.
The laundry doesn’t dry
– Check that the right programme was selected (Extra dry, Thicker garments, Normal dry, Normal garments).
– Check that the laundry is evenly divided on the hangers
– Adjust parameters 2072 and 2071 according to the Parameter Adjustment chapter in the user manual.
